0.12-3.2MM ENAMELED COPPER WINDIGN WIRE SUPER FINE RECTANGULAR COPPER WIRE FOR PROJUCTOR

Modern Flat Enameled Copper Magnet Wire typically uses one to three layers of polymer film insulation, often of two different compositions, to provide a tough, continuous insulating layer. Magnet wire insulating films use (in order of increasing temperature range) polyvinyl formal or Formvar (PVF), polyurethane, polyamide (PUW), polyester (PEW), polyester-polyimide (EIW), polyamide-polyimide (or amide-imide) (AI-EIW), and polyimide (AIW). Polyimide insulated magnet wire is capable of operation at up to 250°C. The insulation of thicker square or or copper magnet wire is often augmented by wrapping it with a high-temperature polyimide or fiberglass tape, and completed windings are often vacuum impregnated with an insulating varnish to improve insulation strength and long-term reliability of the winding.

FEATURES AND BENEIFTS

• Very low capacitance
• High space factor can make it possible to have smaller and thinner coils.
• Lower coils resistance
• Those advantages are highly suitable for surface mount device (SMD) coils.

CERTIFICATES
ISO 9001-2000, ISO TS 16949, ISO 14001-2004,
UL Approved, RoHS Directive Met

APPLICATION

• Transformer
• HID ramp
• Projector
• Planer (lamination)
• Power Generating Machines
• Dynamo
• Wind power
• Motors
• Capstan for digital video camera
• Linear motors
• Voice Coils
• Solenoid Valve(Actuator)

RUIYUAN was established in 2002, located in Tianjin City,the second largest port city in China.We have been focusing on different kinds of high quality wires: enameled round copper wire, rectangular enameled copper triple insulated wire, silk covered Litz wire, bonding wire and special enameled wire for 21 years.Ruiyuan is one of the pioneers in producing micro thin enameled wires below 0.03mm in China. Our R & D team has 20 years of market experience. In 2019, our finest diameter is 0.011mm, and mass production has been achieved. All of our products are UL, RoHS certified, in line with industry standards IEC60317, JIS C 3202, NEMA, NW82.